You can Repeat Step # 1a to 1d then CHECK the “On Battery Power” box and set it to 5.Then be installed and if the battery was completely drained you would need to leave it plugged in for 5 or 6 hours to fully recharge to 100% With the data collector still Powered on and Plugged into the wall charger, the battery should. Turn on the Surveyor and let it stay powered on and plugged in for 4 or 5 minutes without a.With the battery STILL removed – plug in the AC Wall Charger to the top of the Surveyor.After the battery is drained – Remove the battery from the unit by opening the back hatch and lifting it out. Now you can unplug the unit from the AC Wall Charger and leave the screen powered on until the unit turns itself off.Then tap OK in the upper right to save your settings and tap X to return to the Today screen.CHECK the box under “On External Power” and set it for 30minutes.UNCHECK “Turn off device if not used for” under the “On battery power” as shown in the screenshot below.Scroll down and tap the Power Icon then tap the Advanced tab in the bottom left.Tap Start in the upper left / tap Settings / tap the System tab in the bottom left.Exit out of SurvCE by going into File / tap Exit / tap Yes. SURVCE SERIAL NUMBER INSTALL
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |